SC9 Information |
SC9 |
SCSI 1 Terminator, Passive, Single Sided C50 Male |
$9.00
|
|
-
Excellent for impedance matching termination of your average short-run SCSI cables. Take note, however, that terminators designated as 'Passive' only regulate the impedance of the line as opposed to the more efficient 'Active' terminators which use a voltage regulator to optimize signal voltage.
- Centronics 50 Male
-
Centronics 50 Male
At one time this was one of the most common SCSI connectors. Used for scsi-1 applications:
older scanners, controllers, external scsi device cases.
The Centronics 50 connector has 50-pins arranged in two rows one on top of the other.
The top row has 25 pins and the lower row has 25 pins. Used mostly with older 5 MB SCSI-1
Systems. Often called Low-Density SCSI-1 connector. Most SCSI SLOW (5 Mbyte/sec) computers
and host adapters use the Centronics type 50-pin connector. Also some 8-bit Fast computers
and host adapters.
- SCSI 1 - The original standard that was derived from SASI and formally adopted in 1986 by ANSI.
SCSI-1 features an 8-bit bus (with parity), running asynchronously at 3.5 MB/s or 5 MB/s
in synchronous mode, and a maximum bus cable length of 6 meters (just under 20 feet --
compare that to the 18 inch (0.45 meter) limit of the ATA interface). A variation on the
original standard included a high-voltage differential (HVD) implementation whose maximum
cable length was many times that of the single-ended versions.
|
Connectors:
Examples Only - (Connector Shape / Color May Vary Slightly)
- Centronic 50 Male
- Centronic 50 Male
|
SC9
|
SCSI 1 Terminator, Passive, Single Sided C50 Male
|
$9.00
|
|