SC18-3 – 3 Ft. SCSI 2 To SCSI 3, HP50 Male (with Clips) To HP68 Male (with Thumbscrews)

SC18-3 Information
Part Number Description Price Order
SC18-3 3 Ft. SCSI 2 To SCSI 3, HP50 Male (with Clips) To HP68 Male (with Thumbscrews) $39.00
Qty:

  • HP50 (Half Pitch 50) Male to HP68 (Half Pitch 68) Male
    • Half Pitch 50 Male (Micro DB50 Male) - Used for scsi-2 applications: scanner, removable storage drive, controller, external cdr/cdrw. The Micro DB50 connector has 50-pins arranged in two rows one on top of the other. The top row has 25 pins and the lower row has 25 pins. Most 8-bit SCSI FAST (up to 10 Mbytes/sec) computers and host adapters use this 50-pin High-Density connector. Commonly used on Apples and Mac, and some older Sun 8-bit workstations. This connector is seen increased use on Scanners and Iomega Zip Drives.
    • HP68 Male - Probably the most common SCSI connector used today. Used on all SCSI Wide applications and some old DEC single-ended SCSI this connector provides a highly secure connection. Used for scsi-3 applications: scanner, removable storage drive, controller, external cdr/cdrw, ultra/2. The HP68 connector has 68-pins arranged in two rows one on top of the other. The top row has 34 pins and the lower row has 34 pins.
  • SCSI 2 to SCSI 3
    • SCSI 2 - This standard was introduced in 1989 and gave rise to the Fast SCSI and Wide SCSI variants. Fast SCSI doubled the maximum transfer rate to 10 MB/s and Wide SCSI doubled the bus width to 16 bits on top of that (to reach 20 MB/s). However, these improvements came at the minor cost of a reduced maximum cable length to 3 meters. SCSI-2 also specified a 32-bit version of Wide SCSI, which used 2 16-bit cables per bus; this was largely ignored by SCSI device makers because it was expensive and unnecessary, and was officially retired in SCSI-3.
    • SCSI 3 - Before Adaptec and later SCSITA codified the terminology, the first parallel SCSI devices that exceeded the SCSI-2 capabilities were simply designated SCSI-3. These devices, also known as Ultra SCSI and fast-20 SCSI, were introduced in 1992. The bus speed doubled again to 20 MB/s for narrow (8 bit) systems and 40 MB/s for wide. The maximum cable length stayed at 3 meters but ultra SCSI developed an undeserved reputation for extreme sensitivity to cable length and condition (faulty cables, connectors or terminators were often to blame for instability problems).
Connectors:

Examples Only - (Connector Shape / Color May Vary Slightly)

  • HP50 Male
    HP50 Male
  • HP68 Male
    HP68 Male


SC18-3 3 Ft. SCSI 2 To SCSI 3, HP50 Male (with Clips) To 
        HP68 Male (with Thumbscrews)
Part Number Description Price Order
SC18-3 3 Ft. SCSI 2 To SCSI 3, HP50 Male (with Clips) To HP68 Male (with Thumbscrews) $39.00
Qty:
PacificCable.com also sells:
EX12-1EDL
EX12-1EDL - HD15 Male To HD15 Male Left Angle 18 Inches - $26.00 Qty:
MEM2600-16FS-AP - 16MB Flash SIMM Cisco Systems Approved (Misc) - $120.00 Qty:
SCMD1-10
SCMD1-10 - 10 Meter SC - SC Multimode Duplex Core Size: 50/125 - $47.00 Qty:
PT-J623SS-44GR
PT-J623SS-44GR - PCB Side Entry Slim Size Gray RJ9 Jack 50 Pack - $21.00 Qty:
2MEM-PRP-1G - 2 GB SDRAM Kit (2x1GB) Equivalent (Misc) - $441.00 Qty:
© 2011 Pacific Custom Cable, Inc.