You Are Here: PacificCable.com
![]() |
PCC-14-2-50 – 2 Conductor 14 Gauge Flat Adhesive Wire 50 Ft.
PCC-14-2-50 Information | ||||
---|---|---|---|---|
Part Number | Description | Price | Order | |
PCC-14-2-50 | 2 Conductor 14 Gauge Flat Adhesive Wire 50 Ft. | $98.00 | ||
Specifications:
For best results and easy installation, please followthe following instructions:
Using Terminal Blocks - Using scissors, slit the copper conductors down the center about 1/2 inch. Cross one side of the wire on top of the other and fit into terminal block on the side opposite the round wire. Make sure wire is inserted far enough that all bare copper is inside connector. Tighten screws. Attach terminal block to wall or floor with screw. Solder Termination - Pre-tin the ends of the wires using a soldering iron and solder together with the existing systems wires. Let cool and insulate with electrical tape. To Attach Pins - Wires can be attached to many different speakers simply by cutting the wires down the center, placing one wire on top of the other and inserting into pin. Standard speaker pins can be screwed or crimped on. Installing Wire - Peel back 2 inches of the pink liner. Position the tape in the desired location and press to secure. Continue to line up, peel, and press the wire into place along the entire surface. Take care when positioning wire because the adhesive is strong and difficult to remove. To make a turn, fold the wire back and then over itself as in the diagram below. Press as smooth and flat as possible. All products can be painted, spackled, or wallpapered. ![]() ![]() |
||||
![]() |
||||
Part Number | Description | Price | Order | |
PCC-14-2-50 | 2 Conductor 14 Gauge Flat Adhesive Wire 50 Ft. | $98.00 |
PacificCable.com also sells: | |
---|---|
![]() |
|
![]() |
|
![]() |
|
![]() |
|
© 2011 Pacific Custom Cable, Inc. |