![]() Quality Connections Since 1993 |
Custom RF Cable Quick Tool |
SHIPPING ADDRESS: 4170 B Place NW, Auburn, WA 98001 USA View Map |
|
|||
EMAIL: Sales, Customer Service or Webmaster | PHONE: 800-931-3133 or 253-373-0800 | FAX: 253-373-0100 | |||||
Office Hours: 9:00am - 5:00pm PST Monday - Friday | Order Online: 24 Hours | Will Call: 10:00am - 4:00pm PST Monday - Friday |
![]() ![]() ![]() ![]() | |||||
![]() | ||||||
You are here:
PacificCable.com ![]() |
||||||
![]() |
|
Adhesive Backed Video CablePacificCable.com carries Adhesive Backed Video Cable. If you need Adhesive Backed Video Cable not listed here, and/or pinout drawing identified call us at 800-931-3133 or email a request and any documents to sales@pacificcable.com.Flat Adhesive Wire. Simple solution for hiding wire! Easy to use flat wire that is self-adhesive with peel and stick backing. NOTE: All products are for Low Voltage only. Maximum voltage is 12 Volts. See individual item picture pages for more information.
For best results and easy installation, please followthe following instructions:
Using Terminal Blocks - Using scissors, slit the copper conductors down the center about 1/2 inch. Cross one side of the wire on top of the other and fit into terminal block on the side opposite the round wire. Make sure wire is inserted far enough that all bare copper is inside connector. Tighten screws. Attach terminal block to wall or floor with screw. Solder Termination - Pre-tin the ends of the wires using a soldering iron and solder together with the existing systems wires. Let cool and insulate with electrical tape. To Attach Pins - Wires can be attached to many different speakers simply by cutting the wires down the center, placing one wire on top of the other and inserting into pin. Standard speaker pins can be screwed or crimped on. Installing Wire - Peel back 2 inches of the pink liner. Position the tape in the desired location and press to secure. Continue to line up, peel, and press the wire into place along the entire surface. Take care when positioning wire because the adhesive is strong and difficult to remove. To make a turn, fold the wire back and then over itself as in the diagram below. Press as smooth and flat as possible. All products can be painted, spackled, or wallpapered. ![]() ![]()
|